Toyota Hilux Surf 1993 Owner's Manual page 544

SA–44
SUSPENSION AND AXLE –
(d) Connect the upper ball joint to the steering knuckle
and install and torque the nut.
Torque: 142 N–m (1,450 kgf–cm, 105 ft–lbf)
(e) Install a new cotter pin.
2. INSTALL SPACER AND SNAP RING
Install the spacer to the front drive shaft, and using snap
ring pliers, install the snap ring.
If you replace the steering knuckle bushing, recheck the
front drive shaft thrust clearance.
(a) Install the bolt in the shaft.
(b) Using a feeler gauge,measure the front drive shaft
thrust clearance between the steering knuckle out–
side bushing and spacer, by pulling the bolt and ap–
plying 98 IV (10 kgf, 22.0 lbf) of pressure.
Front drive shaft thrust clearance:
If the clearance is not within specification, replace
the spacer.
3. CONNECT STABILIZER BAR TO LOWER SUSPENSION
ARM
Jack up the stabilizer bar and install the retainers, cush–
ions and collar as shown in the figure, and torque the nut.
Torque: 25 N–m (260 kgf–cm, 19 ft–lbf)
4. CONNECT FRONT SHOCK ABSORBER TO LOWER SUS–
PENSION ARM
Torque: 137 N–m (1,400 kgf–cm, 101 ft–lbf)
Front Axle Hub and Steering Knuckle (Steering Knuckle)
Standard clearance
Spacer thickness
1.80 mm
(0.0709 in.)
2.25 mm (0.0886 in.)
0.075 – 0.690 mm
(0.0030 – 0.0272 in.)