AT–206
AUTOMATIC TRANSMISSION
2. INSTALL VALVE BODY
(a) Align the manual valve lever with the manual valve.
(b) Finger tighten the all bolts first. Then tighten the
HINT: Each bolt length (mm, in.) is indicated in the fig–
ure.
Torque: 10 N–m (100 kgf–cm, 7 ft–lbf)
3. CONNECT SOLENOID WIRING
4. INSTALL OIL TUBE
Tap the tubes with a plastic hammer to install the tube
into the position shown in the figure.
NOTICE: Be careful not to bend or damage the tube.
5. INSTALL OIL STRAINER AND GASKETS
(a) Install two new gaskets to the oil strainer case.
–
On–Vehicle Repair
bolts evenly.