Extension Housing Installation - Toyota Hilux Surf 1993 Owner's Manual

AUTOMATIC TRANSMISSION
INSTALLATION OF EXTENSION HOUSING
1. INSTALL NEW GASKET AND EXTENSION HOUSING ON
TRANSMISSION
(a) Clean the threads of the¿¿bolt and bolt hole.
(b) Coat the threads of the¿¿bolt with sealant.
Sealant: Part No. 08833–00080, THREE BOND 1344,
(c) Install the extension housing over a new gasket with
HINT: The two lower bolts are shorter.
Torque: 34 N–m (345 kgf–cm, 25 ft–lbf)
2. INSTALL ENGINE REAR MOUNTING
(a) Install the engine rear mounting to the extension
Torque: 25 N–m (250 kgf–cm, 18 ft–lbf)
(b) Lower and rest the transmission on the mounting
(c) Connect the mounting to the bracket. Tighten the
Torque: 13 N–m (130 kgf–cm, 9 ft–lbf)
3. INSTALL PROPELLER SHAFT
4. INSTALL NO. 1 VEHICLE SPEED SENSOR
(a) Install a new O–ring on the sensor.
(b) Install the vehicle speed sensor with the bolt.
5. CONNECT CONNECTOR
6. LOWER VEHICLE AND CHECK FLUID LEVEL
Start the engine, shift the shift lever into each position,
and then check the fluid level with the transmission in P
position.
Add fluid as necessary.
NOTICE: Do not overfill.
Fluid type: ATF DEXRONEII
– On–Vehicle Repair
LOCTITE 242 or equivalent
bolts, and then torque them.
housing. Tighten the four bolts.
bracket.
four bolts.
AT–35