Toyota Hilux Surf 1993 Owner's Manual page 257

AT–60
AUTOMATIC TRANSMISSION
3. INSPECT THROTTLE CABLE
(a) Depress the accelerator pedal all the way and check
HINT: If the valve does not open fully, adjust the accel–
erator cable.
(b) Fully depress the accelerator pedal.
(c) Measure the distance between the end of the boot
Standard distance: 0–1 mm (0–0.04 in.)
If the distance is not standard, adjust the cable by the ad–
justing nuts.
4. INSPECT SHIFT LEVER POSITION
When shifting the shift lever from the N position to other
positions, check that the lever can be shifted smoothly
and accurately to each position and that the position in–
dicator correctly indicates the position.
If the indicator is not aligned with the correct position,
carry out the following adjustment procedures.
(Column shift)
(a) Remove the nut on the cross shaft rod.
(b) Push the cross shaft rod fully downward.
(c) Return the cross shaft rod two notches to N posi–
(d) Set the shift lever to N position.
(e) While holding the shift lever lightly toward the R po–
(f) Tighten the cross shaft rod nut.
(g) Start the engine and make sure that the vehicle
(a) Remove the nut on the cross shaft rod.
(b) Push the cross shaft rod fully downward.
(c) Return the cross shaft rod three notches to N posi–
(d) Set the shift lever to N position.
(e) While holding the shift lever lightly toward the R po–
(f ) Tighten the cross shaft rod nut.
(g) Start the engine and make sure that the vehicle
5. INSPECT PARK/NEUTRAL POSITION SWITCH
Check that the engine can be started with the shift lever
only in the N or P position, but not in other positions.
If not as stated above, carry out the following adjustment
procedures.
(a) Loosen the park/neutral position switch bolt and set
(b) Align the groove and neutral basic line.
(c) Hold in position and tighten the bolt.
Torque: 13 N–m (130 kgf–cm, 9 in.¿Ibf)
– Troubleshooting (Preliminary Check)
that the throttle valve opens fully.
and stopper on the cable.
tion.
sition side, adjust the cross shaft rod nut.
moves forward when shifting the lever from the N to
D position and reverse when shifting it to the R po–
sition.
(Floor shift)
tion.
sition side, adjust the cross shaft rod nut.
moves forward when shifting the lever from the N to
D position and reverse when shifting it to the R po–
sition.
the shift lever to the N position.