Toyota Hilux Surf 1993 Owner's Manual page 880

BODY ELECTRICAL SYSTEM
(Right Side Door Motor/ Motor Operation)
(Right Side Door Motor/ Circuit Breaker Operation)
3. INSPECT DOOR LOCK CONTROL RELAY
See step 3 of Power Door Lock Control System on page
BE–52.
– Power Window Control System
(a) Connect the positive (+) lead from the battery to
terminal 1 and the negative (–) lead to terminal 2,
check that the motor turns clockwise.
(b) Reverse the polarity, check that the motor turns
counterclockwise.
If operation is not as specified, replace the motor.
(a) Disconnect the connector from the power window
switch.
(b) Connect the positive (+) lead from the battery to
terminal 1 and negative (–) lead to terminal 4 on
the
wire harness side connector, and raise the window
to full closed position.
(c) Continue to apply voltage, check that there is a cir–
cuit breaker operation noise within approximately
4 to 40 seconds.
(d) Reverse the polarity, check that the window begins
to descend within approximately 60 seconds.
If operation is not as specified, replace the motor.
BE–47