Transmission Installation - Toyota Hilux Surf 1993 Owner's Manual

MT1–10
MANUAL TRANSMISSION –
INSTALLATION OF TRANSMISSION
HINT: For the transmission with a transfer (4WD) refer to IN–
STALLATION OF TRANSMISSION WITH TRANSFER on page
MT1–20.
1. PLACE TRANSMISSION AT INSTALLATION POSITION
Insert the extension housing between the member and
floor and then slide the transmission forward.
Align the input shaft spline with the clutch disc, and push
the transmission fully into position.
2.–1 (22R–E)
INSTALL TRANSMISSION BOLTS AND STIFFENER
BOLTS AND STARTER
Torque:
(A) Transmission mounting bolt
(B) Stiffener plate bolt
(C) Starter bolt
2.–2 (3VZ–E)
INSTALL TRANSMISSION BOLTS AND STIFFENER
BOLTS
Torque:
(A) Transmission mounting bolt
(B) Stiffener plate bolt
(C) Starter bolt
3. INSTALL ENGINE REAR MOUNTING AND BRACKET
(a) Install the engine rear mounting. Torque the bolts.
Torque: 25 N – m (260 kgf–cm, 19 ft–lbf)
(b) Raise the transmission slightly by raising the engine
with a jack and a wooden block under the transmis–
sion.
Installation of Transmission
72 N–m (730 kgf–cm, 53 ft–lbf)
37 N–m (380 kgf–cm, 27 ft–lbf)
39 N–m (400 kgf–cm, 29 ft–lbf)
72 N–m (730 kgf–cm, 53 ft–lbf)
37 N–m (380 kgf–cm, 27 ft–lbf)
39 N–m (400 kgf–cm, 29 ft–lbf)