Lower Suspension Arm Bushing Placement; Shock Absorber Inspection; Lower Suspension Arm And Shock Absorber Installation - Toyota Hilux Surf 1993 Owner's Manual

SUSPENSION AND AXLE –
PLACEMENT OF LOWER SUSPENSION ARM
BUSHING
1. REMOVE FRONT AND REAR BUSHINGS
Using SST, press out the bushings from the lower sus–
pension arm.
SST 09726–27011 (09726–02050, 09726–02060)
2. INSTALL FRONT AND REAR BUSHINGS
Using SST, press in new bushings to the lower suspen–
sion arm.
SST 09726–27011 (09726–02040, 09726–02060)
HINT: Do not apply grease or oil to the bushing.
INSPECTION OF SHOCK ABSORBER
INSPECT OPERATION OF SHOCK ABSORBER
INSTALLATION OF LOWER SUSPENSION ARM
AND SHOCK ABSORBER
1. INSTALL LOWER SUSPENSION ARM
(a) Install the lower suspension arm to the frame with
adjusting cams.
(b) Temporarily install the two nuts to the front and rear
adjusting cams.
2. CONNECT LOWER SUSPENSION ARM TO LOWER BALL
JOINT
(a) Connect the lower suspension arm to the lower ball
joint and torque the nut.
Torque: 142 N–m (1,450 kgf –cm, 105 ft–Ibf )
(b) Install a new cotter pin.
Front Suspension (Lower Suspension Arm and Shock
Absorber)
SA–117