Throttle Cable Removal And Installation (A340E) - Toyota Hilux Surf 1993 Owner's Manual

AT–88
AUTOMATIC TRANSMISSION
3. INSTALL PARKING LOCK PAWL BRACKET
(a) Push lock rod fully toward.
(b) Install the three bolts finger tight.
(c) Check that the pawl operates smoothly.
(d) Torque the bolts.
Torque: 7.4 N–m (70 kgf–cm,65 in.¿Ibf)
4. INSTALL VALVE BODY (See page AT–85)
Throttle Cable
REMOVAL OF THROTTLE CABLE
1. DISCONNECT THROTTLE CABLE
(a) Disconnect the cable housing from the bracket.
(b) Disconnect the cable from the throttle linkage.
2. REMOVE VALVE BODY (See page AT–84)
3. PUSH THROTTLE CABLE OUT OF TRANSMISSION CASE
Remove the retaining bolt and pull out the throttle cable.
INSTALLATION OF THROTTLE CABLE
1. INSTALL CABLE IN TRANSMISSION CASE
Install the retaining bolt and push in the throttle cable.
2. INSTALL VALVE BODY (See page AT–85)
3. IF THROTTLE CABLE IS NEW, STAKE STOPPER ON IN–
NER CABLE
(a) Pull the inner cable lightly until a slight resistance is
(b) Stake the stopper as shown, 0.8–1.5 mm (0.031
4. CONNECT THROTTLE CABLE
(a) Connect the cable to the throttle linkage.
(b) Connect the cable housing to the bracket.
5. ADJUST THROTTLE CABLE (See page AT–60)
6. TEST DRIVE VEHICLE
– On–Vehicle Repair
felt, and hold it.
–0.059 in.) in width.