Extension Housing (A340E) - Oil Seal Replacement - Toyota Hilux Surf 1993 Owner's Manual

AUTOMATIC TRANSMISSION
Extension Housing
REPLACEMENT OF OIL SEAL
1. RAISE VEHICLE, AND POSITION PAN TO CATCH ANY
FLUID THAT MAY DRIP
2. REMOVE PROPELLER SHAFT
(See page PR–3)
3. REMOVE REAR OIL SEAL
NOTICE: Clean the rear extension housing before re–
moving the seal.
Using SST, remove the oil seal.
SST 09308–10010
4. INSTALL NEW OIL SEAL
Using SST, drive in a new oil seal as far as it will go.
SST 0932 5–20010
5. INSTALL PROPELLER SHAFT
(See page PR–3)
6. LOWER VEHICLE AND CHECK FLUID LEVEL
Start the engine, shift the shift lever into each position
and, then check the fluid level with the transmission in P
position.
Add fluid as necessary.
NOTICE: Do not overfill.
Fluid type: ATF DEXRON II
– On–Vehicle Repair
AT–89