Toyota Hilux Surf 1993 Owner's Manual page 53

MT1–22
MANUAL TRANSMISSION –
6.–2(22R–E)
INSTALL TRANSMISSION BOLTS AND STIFFENER BOLTS
Torque:
(A) Transmission bolt
(B) Stiffener plate bolt
(C) Starter bolt
7. INSTALL NO.2 FRAME CROSSMEMBER
(a) Raise the transmission slightly with a jack.
(b) Install the No.2 frame crossmember to the side
frame with the bolts. Torque the bolts.
Torque: 95 N–m (970 kgf–cm, 70 ft–lbf)
(c) Lower the transmission and transfer.
(d) Install the four mounting bolts to the engine rear
mounting. Torque the bolts.
Torque: 13 N–m (130 kgf–cm, 9 ft–lbf )
8. INSTALL STABILIZER BRACKET SET BOLTS
Torque: 29 N–m (300 kgf–cm, 22 ft –Ibf)
9.(22R–E)
REMOVE PIECE OF WOOD FROM FRONT AXLE
10. (3VZ–E)
INSTALL THE FRONT DIFFERENTIAL ASSEMBLY
Install and torque the three bolts.
Torque:
Differential carrier cover to frame
Others
11.–1(3VZ–E)
INSTALL EXHAUST PIPE, BRACKET AND CLAMP
(a) Install exhaust pipe to the manifold.
Torque: 62 N–m (630 kgf–cm, 46 ft–Ibf )
(b) Install exhaust pipe bracket to the clutch housing.
Torque: 39 N–m (400 kgf–cm, 29 ft–Ibf )
(c) Install exhaust pipe clamp.
Torque: 19 N–m (195 kgf–cm, 14 ft–Ibf)
Installation of Transmission with Transfer
72 N–m (730 kgf–cm, 53 ft–lbf )
37 N–m (380 kgf–cm, 27 ft–Ibf)
39 N–m (400 kgf–cm, 29 ft–Ibf)
147 N–m (1500 kgf–cm, 108 ft–Ibf )
167 N–m (1700 kgf–cm, 123 ft–Ibf)