PR–10
PROPELLER SHAFT
–
PROPELLER SHAFT
(c) Install the two removed bearing outer races to the
spider.
(d) Using SST, push out the bearing from the yoke.
SST 09332 – 25010
(e) Clamp the outer bearing race in a vise and tap off the
yoke with a hammer.
HINT: Remove the bearing on the opposite side in the
same procedure.
4. SELECT THE SPIDER BEARING
Select the bearing according to whether or not there
is a drill mark on the yoke section.
Yoke
With drill mark
No drill mark
5. INSTALL SPIDER BEARINGS
(a) Apply MP grease to the spider and bearings.
HINT: Be careful not to apply too much grease.
(b) Align the matchmarks on the yoke and shaft.
Bearing
With color mark (Red)
No color mark