Replacement Of High Current Fuse, Medium Current Fuse And Fuse - Toyota Hilux Surf 1993 Owner's Manual

BODY ELECTRICAL SYSTEM
Replacement of High Current Fuse, Medium
Current Fuse and Fuse
HINT: If replacing the fuse be sure to replace it with a
fuse of fusible link with and equal amperege rating.
NOTICE:
1. Turn off all electrical components and the ignition
switch before replacing a fuse or fusible link. Do not
exceed the fuse or fusible link amperage rating.
2. Always use a fuse puller for removing and inserting
a fuse. Remove and insert straight in and out with–
out twisting. Twisting could force open the termi–
nals too much, resulting in a bad connection.
If a fuse or fusible link continues to blow, a short circuit is
indicated. The system must be checked by a qualified
technician.
How to Inspect for System Inspection
This inspection procedure is a simple troubleshooting
which should be carried out on the vehicle during system
operation and was prepared on the assumption of system
component troubles (except for the wires and connec–
tors, etc. ).
Always inspect the trouble taking the following items
into consideration.
• Ground point fault
• Open or short circuit of the wire harness
• Connector or terminal connection fault
• Fuse or fusible link fault
NOTICE:
1. This is an on–vehicle inspection during system oper–
ations. Therefore, inspect the trouble with due re–
gard for security.
2. In case of connecting the battery directly, be careful
not to short circuit, and select the applicable volt–
age.
– General Information
BE–3