Fastener Replacement - Toyota Hilux Surf 1993 Owner's Manual

BO–14
BODY – Moulding
1. REMOVE WIPER ARMS
2. REMOVE COWL LOUVER AND WEATHERSTRIP
3. REMOVE LOWER MOULDING WITH LOWER JOINT
COVERS
(a) Remove five screws from the clips.
(b) Pry up a scraper to loosen the clips from the body.
HINT: Tape the scraper tip before use.
(c) Remove the moulding with lower joint covers and
clips.
4. REMOVE SIDE MOULDING WITH UPPER JOINT COVERS
(a) Install the tip of a scraper between the body and
moulding.
HINT: Tape the scraper tip before use.
(b) Pry up the scraper to loosen the moulding from the
claws of the clips and fasteners.
(c) Remove the moulding with upper joint covers.
5. REMOVE UPPER MOULDING
(a) Using a knife, cut off the upper moulding as shown.
(b) Cut off the old adhesive around the upper moulding
installation area.
NOTICE: Do not damage the body and glass.
REPLACEMENT OF FASTENER
REPLACE FASTENER
(a) Remove the damaged fastener.
(b) Cut off the old adhesive around the fastener instal–
lation area.
NOTICE: Be carefully not to damage the body.
(c) Clean the installation area.
(d) Install new fastener onto the body.