Non-Tilt Steering Column Assembly - Toyota Hilux Surf 1993 Owner's Manual

SR–8
STEERING – Steering Column (Non–Tilt Steering Column)
ASSEMBLY OF NON–TILT STEERING
COLUMN
(See page SR–5)
1. INSTALL UPPER BRACKET TO COLUMN TUBE
(a) Install the upper bracket with two new tapered–head
bolts.
(b) Tighten the tapered–head bolts until the bolt heads
break off.
2. INSTALL MAIN SHAFT TO COLUMN TUBE
(a) Using snap ring pliers, install the snap ring in the
lower groove of the main shaft.
(b) Install the main shaft in the column tube.
HINT: Do not place the ignition key at LOCK position.
(c) Using snap ring pliers, install the upper snap ring.
3. INSTALL COLUMN HOLE COVER
(a) Install the intermediate shaft to the column hole
cover.
(b) Temporarily install the two bolts and dust seal.
4. CONNECT INTERMEDIATE SHAFT WITH MAIN SHAFT
(a) Place the intermediate shaft in the universal joint as
shown.
(b) Temporarily install the bolt.
HINT: After install the column to the body, tighten the
universal joint set bolt and dust seal bolts.