Toyota Hilux Surf 1993 Owner's Manual page 601

SUSPENSION AND AXLE –
8. REMOVE COMPANION FLANGE
(See step 14 on page SA–86)
9. REMOVE FRONT BEARING
(See step 16 on page SA–86)
10. INSTALL NEW BEARING SPACER AND FRONT BEARING
(a) Install a new bearing spacer on the drive pinion.
(b) Install the front bearing on the drive pinion.
11. INSTALL OIL SLINGER AND NEW OIL SEAL
(a) Install the oil slinger.
(b) Using SST, drive in a new oil seal.
SST 09554–30011
Oil seal drive in depth: 1.5 mm (0.059 in.)
(c) Apply MP grease to the oil seal lip.
12. INSTALL COMPANION FLANGE
(a) Using SST, install the companion flange on the
shaft.
SST 09557–22022 (09557–22030)
(b) Coat the threads of a new nut with MP grease.
(c) Using SST to hold the flange, tighten the nut.
Torque the nut.
SST 09330–00021
Torque: 120 N–m (1,225 kgf–cm, 89 ft–lbf)
13. CHECK FRONT BEARING PRELOAD
Using a torque meter, measure the preload of the back–
lash between the drive pinion and ring gear.
Preload (starting):
New bearing
Reused bearing
Front Differential (Disassembly and Assembly of
Differential w/ A D D )
1.2 – 1.9 N–m
(12 – 19 kgf–cm, 10.4 – 16.5 ft–lbf)
0.6 – 1.0 N–m
(6 – 10 kgf–cm, 5.2 – 8.7 ft–lbf)
SA–101