Toyota Hilux Surf 1993 Owner's Manual page 345

AT–148
AUTOMATIC TRANSMISSION
HINT: Each bolt length (mm) is indicated in the figure.
2. CONNECT CONNECTORS TO EACH SOLENOID
3. INSTALL OIL TUBES
Using a plastic hammer, install the three tubes into posi–
tion shown in the figure.
NOTICE: Be careful not to bend or damage the tubes.
4. WHEN REPLACING SOLENOID
(a) Install a new 0–ring to the solenoid.
(b) Install the solenoid and torque the bolt.
Torque: 10 N–m (100 kgf–cm, 7 ft–lbf)
(c) Connect the connector to the solenoid.
(d) Clamp the solenoid wire.
– On–Vehicle Repair
(d) Install the sixteen bolts.
Torque: 10 N–m 0 00 kgf–cm, 7 ft–lbf)
(e) Connect the throttle cable to the cam.