Instrument Panel Removal - Toyota Hilux Surf 1993 Owner's Manual

BO–34
BODY – Instrument Panel
REMOVAL OF INSTRUMENT PANEL
(See pages BO–36 and 37)
1. DISCONNECT BATTERY CABLE FROM NEGATIVE
TERMINAL
2. REMOVE STEERING WHEEL
(See page SR–4)
3. REMOVE STEERING COLUMN COVERS
(See page SR–4)
4. REMOVE ENGINE HOOD RELEASE LEVER
Remove two screws and the engine hood release lever.
5. REMOVE COWL SIDE TRIM
Remove the nut and the cowl side trim.
6. REMOVE INSTRUMENT LOWER CENTER COVER
Remove two clips and the cover.
7. REMOVE KEY CYLINDER COVER
Pry out the key cylinder cover.
8. REMOVE LOWER FINISH NO.1 PANEL
(a) Remove four screws, one bolt and the panel.
(b) Disconnect the connector.
9. REMOVE DUCT HEATER TO REGISTER NO.2
10. REMOVE KNEEPANEL
Remove the three bolts and knee panel.
11. REMOVE HEATER CONTROL PLATE
(a) Pull off the heater control knobs.
(b) (w/ A/C)
Pry off the A/C switch.
(c) Using a screwdriver, pry out the heater control plate
as shown in the illustration, and remove it.
HINT: Tape the screwdriver tip before use.