STEERING
–
STEERING LINKAGE (2WD)
REMOVAL AND INSTALLATION OF STEERING
LINKAGE
Remove and install the parts as shown.
HINT:
When connecting the ball stud to the arm or rod, re–
•
move the grease on the joint surfaces.
After torquing the ball stud nut to specified torque, ad–
•
vance the nut just enough to insert the cotter pin.
After installing any of the steering linkage compo–
•
nents, check the front wheel alignment.
(See page SA–3, 6)
Steering Linkage (2WD)
SR–93