Toyota Hilux Surf 1993 Owner's Manual page 590

SA–90
SUSPENSION AND AXLE –
(g) Stake the case.
7. INSTALL RING GEAR ON DIFFERENTIAL CASE
(a) Clean the contact surfaces of the differential case
and ring gear.
(b) Heat the ring gear in boiling water.
(c) After the moisture on the ring gear has completely
evaporated, quickly install the ring gear to the differ–
ential case.
(d) Align the matchmarks on the ring gear and differen–
tial case.
(e) Coat the ring gear set bolts with gear oil.
(f) Temporarily install the lock plates and set bolts.
(g) After the ring gear cools down enough, tighten the
set bolts uniformly and a little at a time.
Torque: 97 N–m(985 kgf–cm, 71 ft–lbf)
(h) Using a hammer and drift punch, stake the lick
plates.
HINT: Stake one claw flush with the flat surface of
the nut. For the claw contacting the protruding por-
tion of the nut, stake only the half on the tightening
side.
8. INSTALL SIDE BEARINGS
Using a press and SST, install the side bearings to the dif
ferential case.
SST 09226–10010, 09950–20017
Front Differential (Disassembly and Assembly of
Differential w/ A D D )