BR–96
BRAKE SYSTEM
–
Rear–Wheel Anti–Lock Brake System
Speed Sensor
INSPECTION OF SPEED SENSOR
1. INSPECT SENSOR INSTALLATION
Check that the sensor installation bolt is tightened prop–
erly.
If not, tighten the bolt.
Torque: 19 N–m (195 kgf–cm, 14 ft–lbf)
2. INSPECT SPEED SENSOR
(a) Disconnect the speed sensor connector.
(b) Measure the resistance between terminals.
Resistance: 580 – 700
If resistance value is not as specified, replace the sensor.
(c) Check that there is no continuity between each ter–
minal and sensor body.
If there is continuity, replace the sensor.
(d) Connect the speed sensor connector.