Steering Knuckle Installation - Toyota Hilux Surf 1993 Owner's Manual

SA–16
SUSPENSION AND AXLE –
INSTALLATION OF STEERING KNUCKLE
1. INSTALL STEERING KNUCKLE
(a) Support the lower arm with a jack.
(b) Install the steering knuckle to the upper ball joint
and install the nut.
(c) Push the upper arm and steering knuckle down and
install the steering knuckle to the lower ball joint and
install the nut.
(d) Torque the upper ball joint nut.
Torque: 108 N– m (1,100 kgf–cm, 80 ft–Ibf )
(e) Torque the lower ball joint nut.
Torque: 142 N–m (1,450 kgf–cm, 105 ft–lbf )
(f) Install new cotter pins.
2. INSTALL KNUCKLE ARM AND DUST COVER
(a) Install the knuckle arm and the dust cover.
(b) Torque the bolts and nuts.
Torque: 108 N–m (1,100 kgf–cm, 80 ft–lbf)
(c) Secure the nuts with new cotter pins.
3. INSTALL FRONT AXLE HUB AND BRAKE CALIPER
(See page SA–13)
4. CHECK FRONT WHEEL ALIGNMENT
(See page SA–3)
Front Axle Hub and Steering Knuckle (Steering Knuckle)