Antenna Rod Removal And Installation - Toyota Hilux Surf 1993 Owner's Manual

BODY ELECTRICAL SYSTEM
REMOVAL AND INSTALLATION OF ANTENNA
ROD
1. REMOVE ANTENNA ROD
HINT: Perform this operation with the battery negative
(–) cable connected to the battery terminal.
(a) Turn the ignition switch to "LOCK" position.
(b) Remove the antenna nut.
(c) Press the "AM" button on the radio receiver, and si–
HINT:
• The rod will extend fully and be released from the mo–
tor antenna.
• After removing the antenna rod, leave the ignition
switch at "ACC".
2. INSTALL ANTENNA ROD
(a) Insert the cable of the rod until it reaches the bot–
HINT:
• When inserting the cable, the teeth on the cable must
face toward the rear of the vehicle.
• Insert the antenna approx. 300 mm (11.8 in.)
(b) Wind the cable to retract the rod by turning the igni–
HINT:
• If the ignition switch is already in "LOCK" position,
perform step 1
(c) first, then turn the ignition switch to
• In case the cable is not wound, twist it as shown in the
illustration.
• Even if the rod has not retracted fully, install the an–
tenna nut and inspect the antenna rod operation. It will
finally retract fully.
(c) Inspect the antenna rod operation by pushing the
– Audio System
multaneously turn the ignition switch to "ACC" po–
sition.
tom.
tion switch to "LOCK" position.
"ACC" position.
radio wave band select buttons.
BE–109