Toyota Hilux Surf 1993 Owner's Manual page 660

SA–160
SUSPENSION AND AXLE –
2. INSTALL U–BOLTS
(a) Install the pads and pad retainer on the leaf spring.
(b) (4WD)
Install the spring bumper.
M Install the spring seat, U–bolts, washers and nuts.
(d) Tighten the U–bolt mounting nuts.
Torque:
2W D 0.5 ton
4WD Xtra cab 123 N–m
(1,250 kgf–cm, 90 ft–lbf )
HINT: Tighten the U–bolts so that the length of all the
U–bolts under the spring seat are the same.
3. INSTALL REAR SHOCK ABSORBER
(a) Connect the shock absorber to the frame with the
bolt. Tighten the bolt.
Torque: 2WD 25 N–m (260 kgf–cm, 19 ft–lbf)
(b) Connect the shock absorber to the spring seat with
the bolt. Tighten the bolt.
Torque: 2WD 25 N–m (260 kgf–cm, 19 ft–lbf)
4. (4WD)
CONNECT PARKING BRAKE CABLE
5. STABILIZE SUSPENSION
(a) Install the wheel.
(b) Remove the stands and bounce the vehicle up and
down to stabilize the suspension.
Rear Suspension (Leaf Spring
147 N–m
(1,500 kgf–cm, 108 ft–lbf)
1 ton, C&C 123 N–m
(1,250 kgf–cm, 90 ft–lbf)
Regular Cab 147 N–m
(1,500 kgf–cm, 108 ft–lbf)
4WD 72 N–m (730 kgf–cm, 53 ft–lbf)
4WD 72 N–m (730 kgf–cm, 53 ft–lbf)