BRAKE SYSTEM (STATION WAGON) - ANTI-LOCK BRAKE SYSTEM (ABS)
(c)
Check that there is no continuity between each terminal
and sensor body.
If there is continuity, replace the sensor.
(d)
Connect the speed sensor connector.
2.
INSPECT SENSOR INSTALLATION
Check that the sensor installation bolt is tightened proper-
ly. If not, tighten the bolt.
Torque:
18 Nm (184 kgf-cm, 13 ft-lbf)
3.
VISUALLY INSPECT SENSOR ROTOR SERRATIONS
(a)
Remove the axle hub with disc.
(See pub No. RM184E, page SA-16)
(b)
Inspect the sensor rotor serrations for scratches, cracks,
warping or missing teeth.
(c)
Install the axle hub with disc.
(See pub No. RM184E, page SA-19)
FRONT SPEED SENSOR AND SENSOR ROTOR
SERRATIONS INSPECTION
(REFERENCE)
INSPECT FRONT SPEED SENSOR AND SENSOR ROTOR SER-
RATIONS BY USING AN OSCILLOSCOPE
(a)
Connect an oscilloscope to the speed sensor connector.
(b)
Run the vehicle at 20 km/h (12.4 mph), and inspect
speed sensor output wave.
(c)
Check that C is 0.5 V or more.
If not as specified, replace the speed sensor.
(d)
Check that B is 50 % or more of A.
If not as specified, replace the sensor rotor.
BR-47