Toyota Hilux Surf 1993 Owner's Manual page 588

SUSPENSION AND AXLE –
2. REPLACE DRIVE PINION FRONT AND REAR BEARING
OUTER RACES
(a) Using a brass bar and hammer, drive out the outer
race.
(b) Using SST, drive in a new outer race.
SST 09608–35014
Front outer race (09608–06020, 09608–06120)
Rear outer race (09608–06020, 09608–06110)
3. REMOVE SIDE BEARING FROM DIFFERENTIAL CASE
Using SST, remove the side bearing from the differential
case.
SST 09950–20017
HINT: Fix the claws of SST to the notches in the differ–
ential case.
4. REMOVE RING GEAR
(a) Remove the ring gear set bolts and lock plates.
(b) Place matchmarks on the ring gear and differential
case.
(c) Using a plastic–faced hammer, tap on the ring gear
to separate it from the differential case.
5. DISASSEMBLE DIFFERENTIAL CASE
(a) Using a hammer and punch, drive out the straight
pin. Remove the pinion shaft, two pinion gears, two
side gears and four thrust washers.
(b) Using a hammer and brass bar, drive out the needle
bearings.
Front Differential (Disassembly and Assembly of
Differential w/ A D D )
SA–88