Toyota Hilux Surf 1993 Owner's Manual page 160

MANUAL TRANSMISSION –
HINT:
• When replacing either a synchronizer ring or
gear, apply a small amount of fine compound
between the synchronizer ring and gear cone.
Lightly rub the synchronizer ring and gear cone
together.
• When replacing both the synchronizer ring and
gear, there is no need to apply any compound or
to rub them together.
NOTICE: Wash off completely the fine lapping com-
pound after rubbing.
BEARING REPLACEMENT
IF NECESSARY, REPLACE INPUT SHAFT BEARING
(a) Using a snap ring expander, remove the snap ring.
(b) Using a press, remove the bearing.
(c) Using SST and a press, install a new bearing.
SST 09506–35010
INPUT SHAFT
MT2–23