MT2–22
MANUAL TRANSMISSION
–
INPUT SHAFT
COMPONENTS
INPUT SHAFT INSPECTION
INSPECT SYNCHRONIZER RING
(a) Check for wear or damage.
(b) Check the braking effect of the synchronizer ring.
Turn the synchronizer ring in one direction while
pushing it to the gear cone and check that the ring is
locked.
If the braking effect is insufficient, apply a small
amount of fine lapping compound between the
synchronizer ring and gear cone.
NOTICE:
Wash off completely the fine lapping compound
•
after rubbing
Check again the braking effect of the synchronizer
•
ring.
(c) Using a feeler gauge, measure the clearance between
the synchronizer ring back and the gear spline end.
Minimum clearance:
INPUT SHAFT
.
0.5 mm (0.020 in:)