Toyota Hilux Surf 1993 Owner's Manual page 439

TRANSFER – Assembly of Transfer
6. INSTALL REDUCTION GEAR CASE WITH NEW GASKET
TO FRONT CASE
(a) Place a new gasket on the front case.
(b) Install the reduction gear case together with the in–
put gear and counter gear.
(c) Install and torque the bolts as shown in the figure.
Torque:
(A) Bolt length 47 mm (1.85 in.)
39 N–m (400 kgf–cm, 29 ft–lbf)
(B) Bolt length 49 mm (1.93 in.)
39 N–m (400 kgf–cm, 29 ft–lbf)
7. INSTALL FRONT DRIVE GEAR
(a) Using a plastic hammer, install the front drive gear.
(b) Using snap ring pliers, install the snap ring.
8. INSTALL BEARING RETAINER WITH NEW GASKET
(a) Place a new gasket on the front case.
(b) Apply MP grease to the oil seal.
(c) Install the bearing retainer.
(d) Install and torque the bolts.
Torque: 18 N–m (185 kgf–cm, 13 ft–lbf)
9. INSTALL HIGH AND LOW SHIFT FORK SHAFT
(a) Install the high and low shift fork shaft to the No.2
shift fork.
TF–27