SR–76
STEERING
–
Power Steering (Gear Housing)
(MAIN POINT OF REMOVAL AND
INSTALLATION)
1. REMOVE RESERVOIR TANK
2. REMOVE AIR CLEANER ASSEMBLY
3. DISCONNECT UNIVERSAL JOINT
(a) Loosen the column side set bolt.
(b) Remove the gear side set bolt.
(c) Place matchmarks on the universal joint and worm
shaft.
(d) Slide the shaft rearward to disconnect the shaft
from the worm shaft.
4. DISCONNECT AND CONNECT PITMAN ARM
(a) Remove the pitman arm set nut.
(b) Using SST, disconnect the pitman arm from the gear
housing.
SST 09628–62011
(c) When connecting, align the alignment marks on the
sector shaft and pitman arm and install it.
5. DISCONNECT PRESSURE TUBE FROM GEAR HOUSING
Using SST, disconnect the pressure tube from the gear
housing.
SST 09631–22020