Toyota Hilux Surf 1993 Owner's Manual page 693

BR–60
BRAKE SYSTEM – Rear Brake – 4WD
(g) Install the parking brake cable No.2 to the parking
brake bellcrank No. 1 or No. 2.
(h) Hook the bellcrank No. 3 to the cable No. 2, and
then install the bellcrank No.3 with a new C–
washer.
2. APPLY LITHIUM SOAP BASE GLYCOL GREASE TO
FOLLOWING PARTS:
(a) Two piston cups
(b) Two pistons
3. ASSEMBLE WHEEL CYLINDER
(a) Install the cup to the each piston.
(b) Install the spring and two pistons into the wheel
cylinder. Make sure flanges of the cups are
pointed inward.
(c) Install the two boots.
4. INSTALL WHEEL CYLINDER
(a) Install the wheel cylinder on the backing plate
with two bolts.
Torque: 10 N–m (100 kgf–cm, 7 ft–lbf)
(b) Using SST, connect the brake tube.
SST 09751–36011
Torque: 15 N–m (155 kgf –cm, 11 ft–lbf)
5. APPLY HIGH TEMPERATURE GREASE TO BACKING
PLATE AND ADJUSTER
(a) Apply high temperature grease to the brake shoe
contact surfaces as shown.