TRANSFER
–
Component Parts (Idler Gear)
Idler Gear
COMPONENTS
REPLACEMENT OF BEARING
1. IF NECESSARY, REPLACE IDLER GEAR REAR
BEARING
(a) Using snap ring pliers, remove the snap ring.
(b) Using a press and 19 mm socket wrench, remove
the bearing.
(c) Using SST and a press, press in a new bearing.
SST 09316–60010 (09316–00020)
(d) Select a snap ring that will allow minimum axial play
and install it on the shaft.
Maximum play: 0.15 mm (0.0059 in.)
Mark
mm(in.)
Thickness
TF–15