Cruise Control System: Output Of Diagnostic Trouble Code - Toyota Hilux Surf 1993 Owner's Manual

Conditions
No.
Push the cruise control switch
SET/COAST on.
Push the cruise control switch
RESUMEIACCEL on.
Vacuum switch is turned ON.
Each cancel switch turned ON.
• Cruise control switch (to CANCEL)
• Stop light switch
• Park/Neutral Position switch
(to N or P Position)
• Clutch switch
• Parking brake switch
Drive approx. 40 km/h (25 mph) or
over.
Drive approx. 40 km/h (25 mph) or
below.
BODY ELECTRICAL SYSTEM
Diagnosis System
Output of Diagnostic Trouble Code
READ DIAGNOSTIC TROUBLE CODE
(Type A)
(a) Turn the ignition switch on.
(b) Push the SET/COAST switch on, and keep it on.
(c) Push the main switch on.
(d) Check that the indicator light "CRUISE" light–on in
(e) Turn the SET/COAST switch off.
(f) Meet the conditions listed below.
(g) Read the diagnostic trouble code on the indicator
HINT:
• Indication codes appear in order from No. 1.
• If there is no indication code, perform diagnosis and in–
spection. (See page BE–64)
• Indication is stopped, when the MAIN switch is re–
pushed.
– Cruise Control System
the combination meter and after 3 seconds check
that the indicator light "CRUISE" blinks.
light "CRUISE".
Indication code
BE–61
Diagnosis
SET/COAST circuit is
normal.
RESUMEIACCEL circuit is
normal.
Vacuum switch circuit is
normal.
Each cancel switch is
normal.
Speed sensor circuit is
normal.
Speed sensor circuit is
normal.