Toyota Hilux Surf 1993 Owner's Manual page 964

BODY – Windshield
6. APPLY ADHESIVE
(a) Cut off the tip of the cartridge nozzle to make a hole
5 mm (0.20 in.) in diameter. Fill the cartridge with
adhesive.
(b) Load the cartridge into the sealer gun.
(c) Coat the glass with adhesive on all contact surfaces
along the ridge.
Adhesive height:
If adhesive remains on the body
3.5 – 5.0 mm (0.138 – 0.197 in.)
If no adhesive remains on the body
8 – 10 mm (0.31 – 0.39 in.)
7. INSTALL GLASS
(a) Position the glass so that the reference marks are
lined up, and press in gently along the rim.
(b) Using a spatula, apply adhesive on the glass rim.
(c) Use a spatula to remove any excess or protruding
adhesive.
(d) Fasten glass securely until the adhesive sets.
8. INSPECT FOR LEAKS AND REPAIR
(a) Perform a leak test after the hardening time has
elapsed.
(b) Seal any leaks with auto glass sealer.
Part No. 08833–00030 or equivalent
9. INSTALL CLIPS AND WINDSHIELD MOULDING
(See page BO–13)
10. INSTALL FOLLOWING PARTS:
(See page BO–18)
• Inner rear view mirror
• Sun visors and holders
• Front pillar garnishes
• Cowl louver
• Wiper arms
BO–21