Parking Lock Pawl Removal (A340F); Throttle Cable Removal (A340F) - Toyota Hilux Surf 1993 Owner's Manual

AT–208
AUTOMATIC TRANSMISSION
8. FILL TRANSMISSION WITH ATF
Add only about two liters of ATF. Start the engine and
shift through all the positions. Check the fluid level and
add as necessary.
NOTICE: Do not overfill.
Fluid type: ATF DEXRONE II
Parking Lock Pawl
REMOVAL OF PARKING LOCK PAWL
1. REMOVE VALVE BODY (See page AT–204)
2. REMOVE PARKING LOCK PAWL BRACKET
Remove the three bolts and the bracket.
3. REMOVE SPRING FROM PARKING LOCK PAWL PIVOT
PIN
4. REMOVE PIVOT PIN AND PARKING LOCK PAWL
INSTALLATION OF PARKING LOCK PAWL
1. INSTALL PARKING LOCK PAWL AND PIVOT PIN
2. INSTALL SPRING
3. INSTALL PARKING LOCK PAWL BRACKET
(a) Push lock rod fully toward.
(b) Install the three bolts finger tight.
(c) Check that the pawl operates smoothly.
(d) Torque the bolts.
Torque: 7.4 N–m (75 kgf–cm, 65, in.–Ibf)
4. INSTALL VALVE BODY (See page AT–204)
Throttle Cable
REMOVAL OF THROTTLE CABLE
1. DISCONNECT THROTTLE CABLE
Disconnect the cable from the throttle linkage.
– On–Vehicle Repair