AUTOMATIC TRANSMISSION
Parking Lock Pawl
REMOVAL OF PARKING LOCK PAWL
1. REMOVE VALVE BODY (See page AT–28)
2. REMOVE PARKING LOCK PAWL BRACKET
Remove the two bolts and the bracket.
3. REMOVE SPRING FROM PARKING LOCK PAWL PIVOT
PIN
4. REMOVE PIVOT PIN AND PARKING LOCK PAWL
INSTALLATION OF PARKING LOCK PAWL
1. INSTALL PARKING LOCK PAWL AND PIVOT PIN
2. INSTALL SPRING
3. INSTALL VALVE BODY (See page AT–29)
(a) Push lock rod fully toward.
(b) Install the two bolts finger tight
(c) Check that the pawl operates smoothly.
(d) Torque the bolts.
Torque: 7.4 N.m (75 kgf.cm, 65 in.
4. INSTALL VALVE BODY (See page
Throttle Cable
REMOVAL OF THROTTLE CABLE
1. DISCONNECT THROTTLE CABLE
(a) Disconnect the cable housing from the bracket.
(b) Disconnect the cable from the throttle linkage.
(c) Disconnect the cable from the torque converter
–
On–Vehicle Repair
clutch housing.
AT–31
. lbf)
AT–29
)