BO–20
BODY
–
Windshield
INSTALLATION OF WINDSHIELD
(See pages
BO–13
and 18)
1. CLEAN CONTACT SURFACE OF GLASS
Using cleaner, clean the contact surface 15 – 30 mm
(0.59 – 1.18) wide around the entire glass rim.
2. INSTALL DAM
(a) Apply double–stick tape at a point as shown.
(b) Place the dam on the double–stick tape.
NOTICE: Do not touch the glass face after cleaning it.
3. COAT CONTACT SURFACE OF BODY WITH PRIMER
"M"
Using a brush, coat the contact surface on the body with
Primer M.
NOTICE:
• Let the Primer coating dry for 10 minutes or more.
Make sure that the installation of the glass is finished
within 2 hours.
• Use care not to leave any part of the contact surface
uncoated or excessively coated, as Primer M and G
serve to boost the adhesive power of the adhesive to
the glass or body.
• Do not keep any of the opened Primer M and G for later
use.
4. COAT CONTACT SURFACE OF GLASS WITH PRIMER
"G"
(a) Using a brush or sponge, coat the edge of the glass
and the contact surface with Primer G.
(b) Before the Primer dries, wipe it off with a clean cloth
to avoid too thick a coat.
NOTICE: Be sure that installation of the glass is finished
within 70 minutes.
5. MIX ADHESIVE COATING
NOTICE:
• Be sure that installation of the glass is finished within
usable time. (See step 2 on page
• The mixture should be made in 5 minutes or less.
(a) Thoroughly clean the glass plate and putty spatula
with cleaner.
(b) Thoroughly mix 500 g (17.64 oz.) of the main agent
and 75 g (2.65 oz.) of the hardening agent on a
glass plate or like object with a putty spatula.
BO–17
)