Toyota Hilux Surf 1993 Owner's Manual page 190

MANUAL TRANSMISSION –
21. INSTALL OIL SEPARATOR
Install the oil receiver and torque the two bolts.
Torque: 18 N–m (185 kgf–cm, 13 ft–tbf)
22. DISMOUNT INTERMEDIATE PLATE FROM VISE
(a) Dismount the intermediate plate from the vise.
(b) Remove the bolts, nuts, plate washers and gasket.
23. INSTALL TRANSMISSION CASE TO INTERMEDI–
ATE PLATE
(a) Remove the any packing material and be careful not
to drop oil on the contacting surface of the trans–
mission case or intermediate plate.
(b) Apply seal packing to the transmission case as shown.
Seal packing:
Part No. 08826 – 00090, THREE BOND 1281 or
equivalent
(c) Align the each bearing outer race and each shift fork
shaft end with the case holes.
(d) Using a plastic hammer, tap on the case to install it.
24. INSTALL BEARING SNAP RINGS
Using a snap ring expander, install the two snap rings.
COMPONENT PARTS INSTALLATION
MT2–53