Toyota Hilux Surf 1993 Owner's Manual page 598

SA–98
SUSPENSION AND AXLE –
(f) Remove the plate washers and differential case.
(g) Install the plate washer into the lower part of the
carrier.
(h) Place the other plate washer onto the differential
case together with the outer race, and install the dif–
ferential case with the outer race into the carrier.
(i) Using a plastic–faced hammer, snug down the
washer and bearing by tapping the ring gear.
(j) Using a dial indicator, measure the ring gear back–
lash.
Backlash: 0.13 – 0.18 mm (0.0051 – 0.0071 in.)
(k) If not within specification, adjust by either increas–
ing or decreasing the number of washers on both
sides by an equal amount.
HINT: There should be no clearance between the
plate washer and case.
Insure that there is ring gear backlash.
Front Differential (Disassembly and Assembly of
Differential w/ A D D )