Toyota Hilux Surf 1993 Owner's Manual page 31

CLUTCH – Clutch Unit
2. INSTALL CLUTCH COVER
(a) Align the matchmarks on the clutch cover and fly–
wheel.
(b) Torque the bolts on the clutch cover in the order
shown.
Torque: 19 N–m (195 kgf–cm, 14 ft–lbf)
HINT: Temporarily tighten the No. 1 and No. 2 bolts.
3. CHECK DIAPHRAGM SPRING TIP ALIGNMENT
Using a dial indicator with roller instrument, check the di–
aphragm spring tip alignment.
Maximum non–alignment: 0.5 mm (0.020 in.)
If alignment is not as specified, using SST, adjust the di–
aphragm spring tip alignment.
SST 09333–00013
4. APPLY MOLYBDENUM DISULPHIDE LITHIUM BASE
GREASE (NLGI NO.2) OR MP GREASE
Apply molybdenum disulphide lithium base grease to the
following parts:
Release fork and hub contact point
•
Release fork and push rod contact point
•
Release fork pivot point
•
Clutch disc spline
•
5. INSTALL BOOT, FORK, HUB AND BEARING ON
TRANSMISSION
6. INSTALL TRANSMISSION
(See pages MT–5, TF–4)
CL–15