AT–86
AUTOMATIC TRANSMISSION
3.
CONNECT SOLENOID WIRING
4.
INSTALL OIL TUBES
Tap the tubes with a plastic hammer to install them into
the positions in the figure.
NOTICE: Be careful not to bend or damage the tubes.
5. INSTALL OIL STRAINER
Be sure the screen is clean. Torque the bolts.
Torque: 5.4 N–m (55 kgf–cm, 48 in.¿Ibf)
6. INSTALL OIL PAN
(a) Remove any packing material and be careful not to
(b) Apply seal packing to the oil pan shown in the fig–
–
On–Vehicle Repair
(b) Finger tighten the all bolts first. Then tighten the
bolts evenly.
HINT: Each bolt length (mm, in.) is indicated in the fig–
ure.
Torque: 10 N–m (100 kgf–cm, 7 ft–lbf)
drop oil on the contacting surfaces of the transrris–
sion case and oil pan.
ure.
Seal packing: Part No. 08826–00090, THREE BOND
1281 or equivalent