Preparation For Windshield Installation - Toyota Hilux Surf 1993 Owner's Manual

BODY – Windshield
4. REMOVE WINDSHIELD GLASS
(a) Push piano wire through from the interior.
(b) Tie both wire ends to the wooden blocks or like ob–
jects.
HINT: Apply adhesive tape to the outer surface to keep
the surface from being scratched.
NOTICE: When separating, take care not to damage the
paint and interior and exterior ornaments.
To prevent scratching the safety pad when removing the
windshield, place a plastic sheet between the piano wire
and safety pad.
Cut the adhesive by pulling the piano wire around it.
(d) Remove the glass.
NOTICE: Leave as much of the adhesive layer on the
body as possible when cutting off the glass.
PREPARATION FOR INSTALLATION
1. CLEAN AND SHAPE CONTACT SURFACE OF BODY
(a) Remove any dam remaining on the body.
(b) Cut away any rough areas with a knife.
HINT: Leave as much of the adhesive layer on the body
as possible.
(c) Clean the cutting surface of the adhesive with a
piece of cloth saturated in cleaner.
HINT: Even if all the adhesive has been removed, clean
the body.
2. IF NECESSARY, REPLACE FASTENERS
(See page BO–14)
3. CLEAN REMOVED GLASS BEFORE INSTALLATION
(a) Using a scraper, remove the adhesive sticking to the
glass.
(b) Using the cleaner, clean the glass.
4. POSITION GLASS
(a) Place the glass in correct position.
(b) Check that all contacting parts of the glass rim are
perfectly even, and do not make contact with the
fasteners.
(c) Mark reference marks between the glass and body.
(d) Remove the glass.
BO–19