Spider Bearing Replacement - Toyota Hilux Surf 1993 Owner's Manual

PROPELLER SHAFT – PROPELLER SHAFT

SPIDER BEARING REPLACEMENT

1. PLACE MATCHMARKS ON SHAFT AND YOKE
2. REMOVE SNAP RINGS
(TOYOTA type)
(a) Slightly tap in the bearing outer races.
(b) Using two screwdrivers, remove the four snap rings
from the grooves.
(DANA type)
(a) Slightly tap in the bearing outer races.
(b) Using snap ring pliers, remove the four snap rings
from the grooves.
3. REMOVE SPIDER BEARINGS
(a) Using SST, push out the bearing from the propeller
shaft.
SST 09332–25010
HINT: Sufficiently raise the part indicated by A so that
it does not come into contact with the bearing.
(b) Clamp the bearing outer race in a vise and tap off the
propeller shaft with a hammer.
HINT: Remove the bearing on opposite side in the
same procedure.
PR–9