Inspection Of Rear Axle Shaft Components; Installation Of Rear Axle Shaft - Toyota Hilux Surf 1993 Owner's Manual

SA–128
SUSPENSION AND AXLE –
INSPECTION OF REAR AXLE SHAFT
COMPONENTS
1. INSPECT REAR AXLE SHAFT
Check for wear, damage or runout.
Maximum runout: 2.0 mm (0.079 in.)
2. INSPECT OIL SEAL FOR WEAR OR DAMAGE
If the oil seal is damaged or worn, replace it.
3. REPLACE OIL SEAL
(a) Using SST, remove the oil seal.
SST 09308–00010
(b) Using SST, drive in the oil seal.
SST 09517–12010
(c) Apply MP grease to the oil seal lip.

INSTALLATION OF REAR AXLE SHAFT

(See page SA–127)
1. APPLY MP GREASE TO OIL SEAL LIP
2. INSTALL REAR AXLE SHAFT
Install the rear axle shaft, six cone washers and spring
washers with nuts.
Torque: 33 N–m (340 kgf–cm, 25 ft–lbf)
HINT: Be careful not to damage the oil seal with the
splines.
Rear Axle Shaft and Axle Hub (Double Tire)