Propeller Shaft Installation (2Wd) - Toyota Hilux Surf 1993 Owner's Manual

PROPELLER SHAFT – PROPELLER SHAFT
2. INSTALL FLANGE ON INTERMEDIATE SHAFT
(a) Coat the splines of the intermediate shaft with MP
grease.
(b) Place the flange on the shaft and align the match–
marks.
HINT: If replacing either the center flange or inter–
mediate shaft, reassemble them so that the front yoke
of the intermediate shaft and the rear yoke of the
propeller shaft are facing in the same direction.
(c) Using SST to hold the flange, press the bearing into
position by tightening down a new nut.
SST 09930–00021
Torque: 181 N–m (1,850 kgf–cm. 134 ft–lbf)
(d) Loosen the nut.
(e) Torque the nut again.
Torque: 69 N–m (700 kgf–cm, 51 ft–lbf)
(f) Using a hammer and punch, stake the nut.
3. INSTALL PROPELLER SHAFT
(a) Align the matchmarks on the flanges and connect the
flanges with four bolts and nuts.
HINT: If replacing either the center flange or inter–
mediate shaft, reassemble them so that the front yoke
of the intermediate shaft and the rear yoke of the
propeller shaft are facing in the same direction.
(d) Torque the bolts and nuts.
Torque:
4WD 3–joint Type 3VZ–E [MT]
76 N–m (780 kgf–cm, 56 ft–lbf)
Others
74 N–m (750 kgf–cm, 54 ft–lbf)
4. INSERT SLEEVE YOKE INTO PROPELLER SHAFT (4
WD)
(a) Apply Mp grease to the propeller shaft spline and
sleeve yoke sliding surface.
(b) Align the matchmarks on the yoke and propeller shaft.
PROPELLER SHAFT INSTALLATION
(2WD)
1. INSERT YOKE IN TRANSMISSION
(a) Remove SST.
SST 09325–20010 or 09325–40010
PR–15