Dell PowerConnect W-7200 Series Reference Manual page 932

show crypto dp
show
show crypto dp [peer <source-ip>]
Descriptions
Displays crypto data packets.
Syntax
Parameter
dp
peer <source-ip>
Usage Guidelines
Use this command to send crypto data packet information to the controller log files, or to clear a crypto ISAKMP
state associated with a specific IP address.
Examples
The command show crypto dp sends debug information to CRYTPO logs.
(host) # show crypto
Datapath debug output sent to CRYPTO logs.
Related Commands
Command
crypto isakmp
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
932 | show crypto dp
Description
Shows crypto latest datapath packets. The output is sent to crypto logs.
Clears crypto ISAKMP state for this IP.
Description
Use this command to configure Internet Key Exchange
(IKE) parameters for the Internet Security Association
and Key Management Protocol (ISAKMP)
Licensing
Base operating system
Mode
Enable and Config modes
Command Mode
Enable or Config mode on master or local
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide