Dell PowerConnect W-7200 Series Reference Manual page 1098

show ipv6 firewall
show ipv6 firewall
Example
This example displays the status of all firewall configurations.
(host) #show ipv6 firewall
Global IPv6 firewall policies
-----------------------------
Policy
------
Monitor ping attack
Monitor TCP SYN attack
Monitor IPv6 sessions attack
Deny inter user bridging
Deny all IPv6 fragments
Per-packet logging
Enforce TCP handshake before allowing data
Prohibit RST replay attack
Session Idle Timeout
Session mirror destination
Prohibit IPv6 Spoofing
Enable IPv6 Stateful Firewall
The output of this command includes the following parameters:
Parameter
Monitor ping attack
Monitor TCP SYN attack
Monitor IPv6 sessions attack
Deny inter user bridging
Deny all IPv6 fragments
Per-packet logging
Enforce TCP handshake before
allowing data
1098 | show ipv6 firewall
Action Rate
------ ----
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Description
If enabled, the controller monitors the number of ICMP pings per
second. If this value exceeds the maximum configured rate, the
controller will register a denial of service attack.
If enabled, the controller monitors the number of TCP SYN messages
per second. If this value exceeds the maximum configured rate, the
controller will register a denial of service attack.
If enabled, the controller monitors the number of TCP session requests
per second. If this value exceeds the maximum configured rate, the
controller will register a denial of service attack sessions.
If enabled this setting prevents the forwarding of Layer-2 traffic between
wired or wireless users. You can configure user role policies that
prevent Layer-3 traffic between users or networks but this does not block
Layer-2 traffic.
If enabled, all IPv6 fragments are dropped.
If active, and logging is enabled for the corresponding session rule, this
feature logs every packet.
If enabled, this feature prevents data from passing between two clients
until the three-way TCP handshake has been performed. Enabling this
option causes mobility to fail. So, disable this option if you have mobile
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Slot/Port
---------