Related Commands; Command History - Dell PowerConnect W-7200 Series Reference Manual

Parameter
VoIP Bandwidth Capacity (kbps)
VoIP Call Handoff Reservation
VoIP Send SIP 100 Trying
VoIP Disconnect Extra Call
VOIP TSPEC Enforcement
VOIP TSPEC Enforcement Period
VoIP Drop SIP Invite and send status code
(client)
VoIP Drop SIP Invite and send status code
(server)

Related Commands

Command
ap system-profile
rf dot11g-radio-profile
rf arm-profile
rf ht-radio-profile
wlan ht-ssid-profile
wlan virtual-ap
wlan voip-cac-profile

Command History

Introduced in ArubaOS 3.0.
706 | show ap config
Description
Shows the maximum bandwidth that can be handled by one
radio, in kbps.
Shows the percentage of call capacity reserved for mobile
VoIP clients on call.
If enabled, the AP sends SIP 100 - trying messages to a call
originator to indicate that the call is proceeding. This is
useful when the SIP invite may be redirected through a
number of servers before reaching the controller.
If enabled, the AP disconnects calls that exceed the high
capacity threshold by sending a deauthentication frame.
Shows if validation of TSPEC requests for call admission
controls is enabled or disabled.
Displays the maximum time for the station to start a call
after the TSPEC request.
Displays the status code sent to the client when a SIP Invite
is dropped.
480: Temporary Unavailable
l
486: Busy Here
l
503: Service Unavailable
l
none: Don't send SIP status code
l
Displays the status code sent to the server when a SIP Invite
is dropped.
480: Temporary Unavailable
l
486: Busy Here
l
503: Service Unavailable
l
none: Don't send SIP status code
l
Description
show ap config
The output of the
content of the profile settings for an individual AP or AP
group. Use the commands displayed in the column to the left
to configure these parameters.
command displays the
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Mode
Enable and Config
modes