Dell PowerConnect W-7200 Series Reference Manual page 512

rft
rft test profile antenna-connectivity ap-name <name> [dest-mac <macaddr> [phy {a|g}| radio
{0|1}]]
rft test profile link-quality {ap-name <name> dest-mac <macaddr> [phy {a|g}|
radio {0|1}] | bssid <bssid> dest-mac <macaddr> | ip-addr <ipaddr>
dest-mac <macaddr> [phy {a|g}|radio {0|1}]}
rft test profile raw {ap-name <name> dest-mac <macaddr> [phy {a|g}|radio {0|1}] | bssid
<bssid> dest-mac <macaddr> | ip-addr <ipaddr> dest-mac <macaddr> [phy {a|g}|radio {0|1}]}
Description
This command is used for RF troubleshooting.
Syntax
Parameter
ap-name
dest-mac
phy
radio
bssid
ip-addr
Syntax
Usage Guidelines
This command can run predefined test profiles for antenna connectivity, link quality, or raw testing. You should only
run these commands when directed to do so by an Dell support representative.
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
512 | rft
Description
Name of the AP that performs the test.
MAC address of the client to be tested.
802.11 type, either a or g.
Radio ID, either 0 or 1.
BSSID of the AP that performs the test.
IP address of the AP that performs the test.
Licensing
Base operating system
Command Mode
Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Range
—
—
a | g
0 | 1
—