Dell PowerConnect W-7200 Series Reference Manual page 488

Parameter
ip6addr
ip6prefix
ipaddr
latitude
link-priority-cellular
<link-priority-cellular>
link-priority-ethernet
<link-priority-ethernet>
longitude
master
mesh-role
mesh-sae
netmask
no
pap-passwd
pap-user
pppoe-chap-secret
488 | provision-ap
Description
Static IPv6 address of the AP.
The prefix of static IPv6 address of the AP.
Static IP address for the AP.
Latitude coordinates of the AP. Use the format: Degrees, Minutes,
Seconds (DMS). For example: 37 22 00 N
Set the priority of the cellular uplink. By default, the cellular uplink is a
lower priority than the wired uplink; making the wired link the primary
link and the cellular link the secondary or backup link.
Configuring the cellular link with a higher priority than your wired link
priority will set your cellular link as the primary controller link.
Set the priority of the wired uplink. Each uplink type has an associated
priority; wired ports having the highest priority by default.
Longitude coordinates of the AP. Use the DMS format.
For example: 122 02 00 W
Name or IP address of the master controller.
Configure the AP to operate as a mesh node. You assign one of three
roles: mesh portal, mesh point or remote mesh point. If you select
"none," the AP operates as a thin AP.
Enable or disable Simultaneous Authentication of Equals (SAE) on a
mesh network. This option offers enhanced security over the default
wpa2-psk-aes mesh security setting, and provides secure, attack-
resistant authentication using a pre-shared key. SAE supports
simultaneous initiation of a key exchange, allowing either party to
initiate an exchange or both parties to initiate a key exchange
simultaneously
To use the SAE feature, you must enable this parameter on all mesh
nodes (points and portals) in the network, to prevent mesh link
connectivity issues.
NOTE: This is a Beta feature only. This parameter should be kept
"disabled" for this release.
Netmask for the IP address.
Negates any configured parameter.
Password Authentication Protocol (PAP) password for the AP.
You can use special characters in the PAP password. Following are the
restrictions:
You cannot use double-byte characters
l
You cannot use a tilde (~)
l
You cannot use a tick (')
l
If you use quotes (single or double), you must use the backslash (\)
l
before and after the password
PAP username for the AP.
PPPoE CHAP secret key for the AP.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Range
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—