show packet-capture
show packet-capture
Description
Displays packet capture status on the controller.
Syntax
No parameters.
Example
The output of this command shows the packet capture configuration details.
(host) # show packet-capture
Current Active Packet Capture Actions(current switch)
=====================================================
Packet filtering TCP with 1 port(s) enabled:
2
Packet filtering UDP with 1 port(s) enabled:
5
Packet filtering for internal messaging opcodes disabled.
Packet filtering for all other packets enabled.
Packet Capture Defaults(across switches and reboots if saved)
============================================================
Packet filtering TCP with 1 port(s) enabled:
2
Packet filtering UDP with 1 port(s) enabled:
5
Packet filtering for internal messaging opcodes disabled.
Packet filtering for all other packets enabled.
Command History
This command was available in ArubaOS 3.3.2
Command Information
Platforms
All platforms
1174 | show packet-capture
Licensing
Base operating system
Command Mode
Config or Enable mode on master or local
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide